1. Spray the nut and the inside of the wrench with WD-40.
  2. Put sand on the oiled surfaces (the nut and the inside of the wrench)
  3. Slide the wrench onto the nut until it seats. When you turn it, the sand will fill in the missing corners, and the nut should break for you.

From: http://www.tradetricks.org/archives/2005_03.html

 
getting_round_rusted_nuts_to_turn.txt · Last modified: 2010/06/16 13:42 by 127.0.0.1
[unknown button type]
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki